Use of an outdated browser To make your Internet experience safer and more enjoyable, you should update your browser to a new version. The update is free. If you use this PC at work, you should contact your IT administrator. Please note that due to the outdated browser this website may not be displayed correctly.
here to ignore this message.
Imprint HAINBUCH GmbH Erdmannhäuser Straße 57 71672 Marbach Tel.: +49 7144.907-0 Fax: +49 7144.18826 firstname.lastname@example.org
Adaptation clamping devices Suitable for I.D. or O.D. clamping, saw cuts or bar work Fast and accurate change-overs in minimal time and at minimal expense The basic clamping device remains mounted on the machine and simultaneously serves as an interface for other clamping devices Clamping in all variants
Extremely fast conversion without detachment of the basic clamping device [1 – 2 min.] Large clamping range and vibration dampening due to vulcanized clamping elements Standard segmented clamping bushings and workpiece end-stops for machining to size available
Jaw clamping with a HAINBUCH chuck or stationary chuck Enlarged clamping range of the basic clamping device Machining between the jaws is possible [milling or drilling] Deadlength clamping Optimum lubrication and insensitive to dirt through lubrication system New: more comfortable assembly mechanism End face axial clamping via neodymium magnet High face-run change-over accuracy High holding force of 140 N/cm² Assembly in 30 seconds without aligning Low-maintenance, resistant to contamination Spring-loaded center Hard metal face driver Assembly in 1 minute without aligning Adaptation possibility via morse taper Assembly in 1 minute without alignment Self-centering of the adaptation in the chuck ≤ 0,003 mm