Chuck TOPlus mini pull-back
Chuck TOPlus mini in use
TOPlus mini
TOPlus mini pull-back
TOPlus mini pull-back in use

Power chuck TOPlus mini

  • Quick change-over to I.D. clamping or 3-jaw clamping [modular system]
  • 25 % higher holding power than SPANNTOP
  • Significantly reduced interference contour
  • Improved tool accessibility
  • Ideal for limited installation space
  • Lower mass
  • Minimal inertia loss compared to 3-jaw chucks
Spannfutter TOPlus
Spannfutter TOPlus Kombi Axzug
Spannfutter TOPlus im Einsatz
TOPlus
TOPlus Kombi Axzug
TOPlus Kombi Axzug im Einsatz

Power chuck TOPlus

Combi pull-back

Workpiece clamping with pull-back effect. Chuck with dismountable endstop plate. Without end-stop plate ideal for machining pipes and bars.

Advantages

  • Workpiece stabilization through axial draw force applied against the workpiece end-stop
  • Prepared for inside and front end-stop
  • Converts to a fully functional »bar chuck« when the end-stop plate is removed

 

Spannfutter SPANNTOP mini
Spannfutter SPANNTOP mini Axzug
Spannfutter SPANNTOP mini im Einsatz
SPANNTOP mini
SPANNTOP mini Axzug
SPANNTOP mini Axzug im Einsatz

Power chuck SPANNTOP mini

  • Quick change-over to I.D. clamping or 3-jaw clamping [modular system]
  • Significantly reduced interference contour
  • Improved tool accessibility
  • Ideal for limited installation space
  • Lower mass
  • Minimal inertia loss compared to 3-jaw chucks
Spannfutter SPANNTOP
Spannfutter SPANNTOP Kombi Axzug
Spannfutter SPANNTOP im Einsatz
SPANNTOP nova
SPANNTOP nova Kombi Axzug
SPANNTOP nova Kombi Axzug im Einsatz

Power chuck SPANNTOP nova

  • Ideal for customers with existing RD clamping heads
  • Typical features of all HAINBUCH power chucks, such as high holding power, parallel clamping with high accuracy and easy set-up
  • Minimal inertia loss compared to 3-jaw chucks
Handspannfutter TOROK SE
Handbetätigtes Spannfutter TOROK
Handspannfutter TOROK im Einsatz
TOROK
TOROK
TOROK im Einsatz

Manual chuck TOROK

  • Also available in a CFRP lightweight design
  • Manual actuation – a clamping cylinder is not required
  • Sensitive clamping possible
  • Workpiece stabilization through axial draw force applied against the
  • Workpiece end-stop
  • Mandrels, jaw modules, face drivers, and morse taper adaptable
Backenfutter B-Top

Jaw chuck B-Top

  • Fast jaw change with individual unlocking
  • Large through-bore with bushing inserts that can be changed from the front
  • Proven wedge rod mechanism
Backenfutter B-Top3

Jaw chuck B-Top3

  • Jaw chuck with quick conversion to a segmented clamping bushing [ I.D. clamping] and a clamping head [O.D. clamping]
  • Fast jaw change with individual unlocking
  • Large through-bore with bushing inserts that can be changed from the front
  • Proven wedge rod mechanism